Table of Contents
Advertisement
7462
MFP stapler assembly sensor (media in stapler) removal
Previous
1. Remove the stapler unit assembly from the . See
"MFP stapler assembly stapler unit assembly
removal" on page
4-212.
2. Using a flat-blade screwdriver, release the tabs (A) securing the sensor.
Next
Go Back
A
3. Using needlenose pliers, carefully grip the sensor and pull it out and disconnect the harness.
Replacement Notes: Using needlenose pliers, place the rear most tab in the sensor bracket first. Then push
on the rear face of the sensor until the other two tabs snap into place.
4-219
Repair information
Advertisement
Table of Contents
