Table of Contents
Advertisement
7462
Sensor (ADF media exit) fan bracket assembly removal
1. Remove the ADF cover, front. See
2. Remove the ADF rear cover. See
3. Open the ADF top door assembly.
4. Disconnect the ground strap, the fan (CN12) harness, and the media exit sensor (CN9) harness.
5. Remove the two screws (A) on the front and rear of the sensor (ADF media exit) fan bracket assembly.
6. Remove screw (B) from the ground strap.
7. Remove the sensor (ADF media exit) fan bracket assembly.
Note: Remove the fan filter cover assembly from the used sensor (ADF media exit) fan bracket assembly, and
install on the new sensor (ADF media exit) fan bracket assembly.
Replacement note: Be sure to reinstall the ground strap.
4-76
Service Manual
"ADF cover, front removal" on page
"ADF cover, rear removal" on page
4-64.
4-65.
Previous
Next
Go Back
Advertisement
Table of Contents
