Removing An M.2 Ssd Enablement Board From The Storeeasy 1650 Expanded Server - HP StoreEasy 1000 Administrator's Manual

IMPORTANT:
M.2 SSD Enablement Board. For information on installing either a full-length or a half-length
M.2 SSD Enablement Board, see the server user guide on the HPE website (http://
www.hpe.com/support/proliantgen9/docs).
8. Install the M.2 SSD Enablement Board slot cover.
9. Install the PCIe riser cage.
10. Install the access panel.
11. Install the server into the rack.
12. Connect each power cord to the server.
13. Connect each power cord to the power source.
14. Power up the server.
The installation is complete.
Removing an M.2 SSD Enablement Board from the StoreEasy 1650
Expanded server
WARNING!
components to cool before touching them.
CAUTION:
precautions before beginning any installation, removal, or replacement procedure. Improper
grounding can cause electrostatic discharge.
To remove the component:
1. Power down the server.
2. Remove all power:
Disconnect each power cord from the power source.
Disconnect each power cord from the server.
3. Remove the server from the rack.
4. Remove the access panel.
5. Remove the air baffle.
Your M.2 SSD Enablement Board might either be a full-length or a half-length
To reduce the risk of personal injury from hot surfaces, allow the internal system
To prevent damage to electrical components, take the appropriate antistatic

Removing an M.2 SSD Enablement Board from the StoreEasy 1650 Expanded server

29