Error Codes; Storage Management Provider Error Codes - HP StoreEasy 1000 Administrator's Manual

Error codes

This section contains the error codes that may occur.

Storage Management Provider error codes

The Storage Management Provider error codes are listed in
Table 8 Storage Management Provider errors
Error code Error message
0x24005001 Error during discovery.
0x24005003 Error while parsing CLI output.
0x20005003 Error while parsing CLI output.
0x25005008 The controller specified was not found.
0x20005009 The specified RAID level is invalid.
0x25005009 The specified RAID level is invalid.
0x2300500B The operation is not supported because the
storage pool is unhealthy.
0x2300500C The operation is not supported because the
storage pool is transforming.
0x2300500D The physical drive specified is already in use.
0x2300500E Less than the minimum number of physical drives
was specified.
0x2300500F The specified physical drives are unsupported for
this operation. They may either be in use or are
a mismatch.
0x24005011 The physical disk was not found in the provider
cache.
0x25005011 The physical disk was not found in the provider
cache.
0x24005012 No physical disks were found in the logical drive.
0x25005013 Failed to update pool in cache.
0x25005014 Failed to get the pool from the controller.
0x25005015 Failed to delete the pool from cache.
0x25005016 Failed to get the pool IDs for the subsystem from
the controller.
Table 8 (page
Recommended action
Restart Storage Management Service.
Restart Storage Management Service.
Restart Storage Management Service.
Update the storage management provider cache by
invoking Windows PowerShell command
Update-StorageProviderCache.
Update the storage management provider cache by
invoking Windows PowerShell command
Update-StorageProviderCache
Update the storage management provider cache by
invoking Windows PowerShell command
Update-StorageProviderCache.
Retry the operation.
Retry the operation.
Retry the operation.
Retry the operation.
Retry the operation.
Restart Storage Management Service.
Update the storage management provider cache by
invoking Windows PowerShell command
Update-StorageProviderCache.
Restart Storage Management Service.
Update the storage management provider cache by
invoking Windows PowerShell command
Update-StorageProviderCache.
Update the storage management provider cache by
invoking Windows PowerShell command
Update-StorageProviderCache.
Update the storage management provider cache by
invoking Windows PowerShell command
Update-StorageProviderCache.
Update the storage management provider cache by
invoking Windows PowerShell command
Update-StorageProviderCache.
159).
Error codes 159