HP StoreEasy 1000 Administrator's Manual page 17

Hide thumbs Also See for StoreEasy 1000:
Table of Contents

Advertisement

Item
1
When these four LEDs flash simultaneously, a power fault has occurred.
2
If the health LED indicates a degraded or critical state, review the system IML or use iLO to review the system health
status.
3
This LED behavior applies to all front drives, and to the rear drives connected to the front drive cage 2 backplane.
4
This LED behavior depends on the iLO 08-HD Max sensor reading.
5
Facility power is not present, power cord is not attached, no power supplies are installed, power supply failure has
occurred, or the front I/O cable is disconnected.
Figure 14 StoreEasy 1650 Expanded Storage rear panel LEDs
Item
1
2
3
4
5
Description
Description
Dedicated iLO activity LED
Dedicated iLO link LED
NIC activity LED
NIC link LED
UID LED
Status
Flashing blue:
1 Hz/cycle per sec = Remote
management or firmware upgrade
in progress
4 Hz/cycle per sec = iLO manual
reboot sequence initiated
8 Hz/cycle per sec = iLO manual
reboot sequence in progress
Off = Deactivated
Status
Solid green = Link to network
Flashing green = Network active
Off = No network activity
Green = Network link
Off = No network link
Solid green = Link to network
Flashing green = Network active
Off = No network activity
Green = Network link
Off = No network link
Solid blue = Activated
Flashing blue:
1 Hz/cycle per sec = Remote
management or firmware upgrade
in progress
4 Hz/cycle per sec = iLO manual
reboot sequence initiated
8 Hz/cycle per sec = iLO manual
reboot sequence in progress
Hardware components
17

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents