HP StoreEasy 1000 Administrator's Manual page 56

IMPORTANT:
Figure 34
You can also import the network configuration using the network configuration file. For more
information on the network configuration file, see
(page 62) and
You can launch the NCT directly using the following methods:
Open a command prompt or PowerShell and type NCT.
Open Server Manager and select Tools→StoreEasy→Configure Networking.
Double-click the System Tools folder on the desktop and click Configure Networking.
Click Configure Networking on the Start screen.
Click the Configure Networking icon on the desktop.
The NCT is divided into two panes. When you launch NCT to configure network interfaces or
validate the network configuration, the network configuration discovery is initiated. When the
system discovery completes, the left pane or interface pane lists the discovered interfaces and
their operational state. The right pane displays the current configuration step. Hovering over a
network interface in the interface pane displays the device name, interface name, and status.
For example, the interface might be disabled, disconnected, or enabled.
IMPORTANT:
any other tool, the changes are reflected in NCT only when you close and relaunch it.
The NCT wizard includes the following sections:
Network Interfaces
Network Team Configuration
56 Managing HPE StoreEasy 1000 Storage
HPE strongly recommends you to use this tool for configuring network interfaces.
"Importing network configuration" (page
While using NCT, if you change the network configuration of the system using
"Managing the network configuration file"
64).