Installing An M.2 Ssd Enablement Board In The Storeeasy 1650 Expanded Storage System - HP StoreEasy 1000 Administrator's Manual

Table 1 Systems Insight Display LEDs and internal health LED combinations (continued)
Systems Insight
Display LED and
color
DIMM (amber)
Over temp
(amber)
PCI riser (amber)
Fan (amber)
Power supply
(amber)
Power cap (off)
Power cap (green)
NOTE: For more information on troubleshooting, refer to the hardware platform information.
The following list identifies the ProLiant model for each HPE StoreEasy 1000 Storage product:
1450—ProLiant DL160 Gen9 server
1550—ProLiant ML110 Gen9 server
1650—ProLiant DL380 Gen9 server
1650 Expanded—Apollo 4200 Gen9 server
1850—ProLiant DL380 Gen9 server
The ProLiant documentation is available at:
http://www.hpe.com/support/proliantgen9/docs
Installing an M.2 SSD Enablement Board in the StoreEasy 1650 Expanded
Storage System
1. Power down the server.
Health LED System power
LED
Red Green
Amber Green
Amber Green
Red Amber
Red Green
Amber Green
Red Green
Red Amber
Amber Green
— Amber
— Flashing green
— Green

Installing an M.2 SSD Enablement Board in the StoreEasy 1650 Expanded Storage System

Status
One or more DIMMs have failed.
DIMM in slot X is in a pre-failure condition.
The Health Driver has detected a cautionary
temperature level.
The server has detected a hardware critical temperature
level.
The PCI riser cage is not seated properly.
One fan has failed or is removed.
Two or more fans have failed or are removed.
One or more of the following conditions may exist:
Only one power supply is installed and that power
supply is in standby.
Power supply fault.
System board fault.
One or more of the following conditions may exist:
Redundant power supply is installed and only one
power supply is functional.
AC power cord is not plugged into redundant power
supply.
Redundant power supply fault.
Power supply mismatch at POST or power supply
mismatch through hot-plug addition.
Standby
Waiting for power
Power is available
27