Table of Contents
Advertisement
3-4 Maintenance
5. Tighten the guide screws.
>
, -
. · · · · \ .
• •
>>
.
'
.
:
> >
•
>
ontroller Soard"G ' ·
Adjustment Sc(,
"'
Figure 3-1.
Controller Board Guide Adjustment
The controller module is installed by reversing this procedure. Make sure that all connectors
are seated firmly.
Drive Module
The drive mechanics module is removed by the following method:
1. Remove power from unit.
2. Remove top, bottom and front covers.
3. Remove controller board.
4. Remove two screws fastening drive to side of chassis, and two screws fastening drive
to bottom of chassis.
5. Remove ac connector and de connector.
6. Slide drive forward, while loosening rear edge connector.
7. Remove drive through front of unit.
The drive module is installed by reversing this procedure. Make sure that the two longer
screws go in the bottom and the two shorter screws go in the side.
Fan Compartment
The fan compartment can be removed by the following procedure:
1. Remove power from the unit.
2. Loosen four screws at corners of compartment; back them out about 1 inch.
Advertisement
Table of Contents
