Network Vlan Configuration - HP StoreEasy 1000 Administrator's Manual

Figure 35

Network VLAN Configuration

NOTE: It is optional to configure VLAN assignments. If you choose not to configure VLAN
assignments, only the default team interface is created. Click Next to skip this step and go to
the IP Address Configuration step.
Network VLAN Configuration enables you to configure VLAN assignments. The default VLAN
ID is 0, but the VLAN IDs can have a value from 0 to 4094. Each VLAN ID assigned to a physical
network interface or network team creates a virtual network interface. Both physical and virtual
interfaces created for network teams can have VLAN IDs assigned to them. If a physical interface
is assigned a VLAN ID, a team is created with a single physical interface. A virtual interface with
the VLAN ID is then created in the team.
To assign VLAN IDs:
1. Select the Configure VLAN IDs now and click Next.
2. Select one of the following options and enter the VLAN ID in the respective fields:
Add a single VLAN ID—Select to add a single VLAN ID.
Add discrete VLAN IDs—Select to add the VLAN IDs as comma separated values.
Add a range of VLAN IDs—Select to specify the VLAN IDs using a start and end value
with an increment. For example, a start value of 2 and an end value of 20 with an
increment of 5 would assign VLAN IDs 2, 7, 12, and 17.
3. Select the Remove the default virtual network interface check box to remove the default
virtual interface from a team. This step is optional.
NOTE:
the team or physical NIC unless you assign one or more VLAN IDs.
4. Click Next to proceed to the Network Interface IP Configuration step.
If a default virtual interface is deleted, the system will not receive any packets on
Using the Network Configuration Tool 59