Installation Conditions; Environmental Conditions - Barco F50 User Manual

5.2

Installation conditions

General
This section contains important physical and environmental information that will help you determine the optimal installation position
and conditions for your projector.
Barco projectors are manufactured according to specific design standards, which also include environmental
conditions. Failing to follow the terms and conditions outlined in this chapter can result in loss of product
warranty.

Environmental conditions

The table below summarizes the physical environment in which the projector may be safely operated or stored.
Environment
Ambient Temperature @
1500 M
Ambient Temperature @
3000 M
Air cleanliness
Relative humidity (RH)
Mains power requirements
Projector
F50
To protect operating personnel, the National Electrical Manufacturers Association (NEMA) recommends that the instrument panel
and cabinet be grounded. In no event shall this projector be operated without an adequate cabinet ground connection.
The AC supply must be installed by a qualified electrician in conformance to local codes. Hardware, wire sizes and conduit types
must comply with local codes.
Ventilation
The projector is fan cooled and must be installed with sufficient space around the projector to ensure sufficient air flow. See image 5-1
Ventilation inlets are located on the left and right sides of the projector. Hot air is exhausted from the rear vent.
500mm
Image 5-1
Projector weight and footprint
Weight: 7.5 kg (exclusive of lens)
Dimensions shown in millimeters (mm).
601–0307–00 F50 25/02/2016
Operating
10 °C (50 °F) to 40 °C (104 °F)
10 °C (50 °F) to 35 °C (95 °F)
Clean office environment (equivalent with cleanroom
standard ISO 14644-1 ISO Class 9)
20% to 80% RH Non-condensed
Power requirements
100 — 240 V, 50 — 60 Hz, 16 A @ 240 V
500mm
5. Installation
Storage
-15 °C (5 °F) to 60 °C (140 °F)
-15 °C (5 °F) to 60 °C (140 °F)
n.a.
10% to 90% RH Non-condensed
31