Ventilation Requirements; Power Down Procedure; Installation Conditions; Failure Indications - Barco FL40 Series Quick Start Manual

Ventilation Requirements

Ventilation Requirements
Caution
Do not place heat sensitive
objects in the area of the
orange arrow
Power up procedure
Connect power
AC
110-240V
1. Plug in mains power cord
2. The projector will run a start up procedure. When completed,
the standby button illuminates white. (Standby mode).
3. Press power button again to bring the projector in ON mode.
When the power button backligh is steady blue,
the projector are ready for use.

Installation Conditions

Installation Conditions
Ambient operating conditions:
Altitude 0 - 1500m:
Temperature: 10 - 40°C
Humidity: 10-80% RH
Altitude 1500 - 3000m
Temperature: 10 - 35°C
Humidity: 10 - 80% RH
NOTE !
The operating conditions will change when dust or pollution filters are installed.
Refer to filter installation manual for correct data

Failure indications

What to do when the content or color is not correct
- Review source information in the status menu (LCD screen or OSD) and verify that the source signal is compatible.
- Check the lenght of the source cables, and try shorter cables
- Use test image to verify that the correct aspect ratio is selected
- Reset color and display settings to factory settings
- Restart the projector. Let the unit cool down for at least 1 minute prior to restarting
Press Power On Button
250mm

Power down procedure

Press Power Button for 3 sec
1. Press the power button for 3 seconds
2. The power button will illuminate white, and
the projector enters the cooling down process.
3. Wait until the cooling down process are
completed before removing the main power
cord from the projector
Power requirements:
100 - 240 V, 60 - 50 Hz
Dimensions excl. lens:
450 x 471 x 244mm (WxLxH)
Weight excl. lens: 21,5 kg
250mm
Pull out Connector
AC
110-240V