Mounting The Projector On A Flat Surface - Barco F50 User Manual

5. Installation
5.5 Mounting the projector on a flat surface
Suggested procedure
1. Place the projector on a pedestal or similar, sturdy object. Make sure that all three projector feet are in contact with the surface
of the installation area.
2. Adjust the projector legs so that so that the projector is completely level. To do this, turn the collar on each foot clockwise or
anti-clockwise until the correct level is achieved.
Lower
Image 5-5
3. In an ideal installation, the projector lens surface is centered with and parallel to the screen. This orientation helps to ensure
optimized lens performance with minimal offset. If this position is not possible (such as when the projector is significantly higher
than the center of the screen), it is better to rely on offset (lens shift) rather than extra tilt. If tilt is required, make sure that it does
not exceed 20 degrees on the side-to-side axis. See "Positioning the projector", page 34 for more information.
36
Raise
601–0307–00 F50 25/02/2016