Synchronization Menu 3D - Barco F50 User Manual

11. Multichannel installations

11.5 Synchronization menu 3D

3D Source sync
Main menu — Installation — Synchronization — 3D source sync
Used to define which input source will be used for left eye/right eye synchronization signal.
The menu options for 3D source sync differ lightly depending on which 3D mode is selected.
See table below for more information:
Menu Frame sequential mode
option
Source The source will determine the order of
the input frames. Accurate only with
DP sources with inband sync. For
other sources this will only be correct
50% of the times and the 3D menu
option, Swap eyes, must be used to
correct the problem.
Sync Use the signal on the selected sync-in
to determine the order of the input
1,2,3
frames.
3D Display sync
Main menu — Installation — Synchronization — 3D source sync
Used to define which display source will be used for left eye/right eye synchronization signal.
The menu options for 3D source sync differ lightly depending on which 3D mode is selected.
See table below for more information:
Menu Frame sequential mode
option
Source Use the order of the input frames
from the source itself. This will only
be correct 50% of the times and the
swap eyes option must be used to
correct the problem.
Sync Use the signal on the selected
1,2,3 sync-in to determine the order of the
input frames.
3D Sync 1
Main menu — Installation — Synchronization — [3D] Sync 1
This menu option is used to select which signal the Sync 1 connector shall send out.
When a Sync in connector (Sync 1,2,3) is used for source or display synchronization it will automatically be
configured as 'input' and it will not be possible to select any type of output for this connector.
Setting Description
Input Used as sync signal to determine the order of input frames.
Display
Sends the sync signal from the 3D display sync source.
sync
Glass Sends a signal that is used to synchronize the shutter glasses. Connect this signal to the IR or RF emitter.
sync
Sync 2 Sends the sync signal from the sync 2 connector.
Sync 3 Sends the sync signal from the sync 2 connector.
3D Sync 2
Main menu — Installation — Synchronization — [3D] Sync 2
This menu option is used to select which signal the Sync 1 connector shall send out.
100
In side by side mode
Not available
Use the signal on the selected
sync-in to determine the order of the
input frames.
In side by side mode
Not available
Use the signal on the selected
sync-in to determine the order of the
input frames.
In dual head mode
Not available
Use the signal on the selected
sync-in to determine the order of the
input frames.
In dual head mode
Not available
Use the signal on the selected
sync-in to determine the order of the
input frames.
601–0307–00 F50 25/02/2016