Wireless Remote Control - Barco F50 User Manual

6. Input and communication
6.3

Wireless remote control

General
The projector has 2 IR receivers, one at the front and one at the rear, which are used to receive signals from the wireless remote
control.
The wireless remote control is powered by two (2) standard AAA batteries. The battery compartment is on the back side of the
remote control (ref. 11, image 6-2).
Functions
1. Info
2. Auto settings
3. Lens shift
SHIFT
4. Navigation arrows
5. Back button
BACK
6. Source selection
Image 6-2
Item No. Name
1
Info
2 Auto settings
3 Lens shift
4 Navigation arrows
5 Back button
6
Source selection
7
Power
8 Hash key
9. OK
10. Menu
11. Battery cover
Specifications
Parameter
Type
Sensors
Carrier
Range
Laser
Disable an IR Receiver on the projector
Each of the IR receivers on the projector operates individually of the other, and can be enabled or disabled as required.
To enable or disable the front IR receiver, go to Main Menu — Installation — IR Front.
To enable or disable the rear IR receiver, go to Main Menu — Installation — IR Rear.
48
7. Power
INFO POWER
i
8. Hash key
9. OK
OK
10. Menu
MENU
SOURCE
11. Battery cover
Description
Shortcut key to activate the projector OSD 'Status' menu
Activates the projector 'Auto' settings
Activates Lens Shift function.
Directional / navigation tolls
Return to previous menu alternative
Toggles forward and backwards between available sources
Switches the projector lamp and electronics ON or OFF
Not in use
Confirms the current selection
Shortcut key to activate or deactivate the on screen menu display (OSD)
Removable battery compartment cover
Value
IR, NEC protocol
2
38 kHz
7m
1 mW, 670nm
601–0307–00 F50 25/02/2016