Installation Process; Installation Conditions - Barco F70 Series User Manual

Physical Installation

4.1 Installation Process

Recommended Installation sequence
Item
1
2
3
4
5
6
7
8

4.2 Installation conditions

Environmental Conditions
Barco projectors are manufactured according to specific design standards, which also include
environmental conditions. Failing to follow the terms and conditions outlined in this chapter can
result in loss of product warranty
The table below summarize the physical environments in which the projector may be safely operated or
stored.
Environment
0 -500m
500 -1500m
1500 - 3000m
Maximum Air Flow
Mains power requirement
Projector
F70
To protect operating personnel, the National Electrical Manufacturers Association (NEMA) recommends that
the instrument panel and cabinet be grounded.
In no event shall this projector be operated without an adequate cabinet ground connection.
The AC supply must be installed by a qualified electrician in conformance to local codes. Hardware, wire sizes
and conduit types must comply with local codes.
Ventilation
The free space necessary between the air intake and exhaust are shown below.
48 601–426-03 F70 Series
Procedure
Confirm that the installation area meets all
technical and environmental requirements
Decide where the projector will be
mounted
Unpack the projector and confirm that all
equipment is present and in good working
order
Mount the projector
Install the projector lens
Connect the source
Power up the projector
Set up the image
Ambient operating
temperature
+10 to +45 °C
+10 to +40 °C
+10 to +35°C
900m 3 /hour
Read more in chapter
See "Installation conditions", page 48
See "Positioning the projector", page 49
See "Initial inspection", page 49
See "Mounting the projector, general
considerations", page 50
See "Replace a lens", page 43
See "Projector source and control
connections", page 60
See "Power up the projector", page 63
See "Image menu", page 75
Relative Humidity
10 –80% RH
10 –80% RH
10 –80% RH
10 –80% RH
Power Requirement
100 –240V. 50 –60 Hz.
Storage condition
–20 to +60 °C, 10 – 90 %
RH
–20 to +60 °C, 10 – 90 %
RH
–20 to +60 °C, 10 – 90 %
RH
Not Applicable