Installing A Lens - Barco F50 User Manual

4.2

Installing a lens

Insert a lens into the lens holder
1. Remove the protection cap on the bayonet side of the lens.
2. Insert the lens, making sure that the red line (marking) on the bayonet is positioned towards the top of the cabinet. The lens
assembly should enter the projector body fully and cleanly.
Caution: The lens is fragile. Do not try to force the lens into position. If there is any resistance, remove the lens from the
projector and then try again.
3. Screw the lens clockwise until it clicks into position.
Remove a lens from the lens holder
Depress the lens release button (reference 1, image 4-2) and then turn the lens anticlockwise until the lens bayonet is clear of the
projector chassis.
Image 4-2
To prevent dust contamination in the projector light processor, always replace the lens bayonet cap, lens cap
and projector lens cap (if applicable) immediately after removing the lens.
601–0307–00 F50 25/02/2016
1
4. Lenses
25