Physical installation
4.1 Installation process
Recommended Installation sequence
Item
1
2
3
4
5
6
7
8
4.2 Installation conditions
Environmental Conditions
Barco projectors are manufactured according to specific design standards, which also include
environmental conditions. Failing to follow the terms and conditions outlined in this chapter can
result in loss of product warranty
The table below summarize the physical environments in which the projector may be safely operated or
stored.
Environment
0 -1500m
1500 -3000m
Maximum Air Flow
Mains power requirement
Projector
FL40 / FS40 projectors
To protect operating personnel, the National Electrical Manufacturers Association (NEMA) recommends that
the instrument panel and cabinet be grounded.
In no event shall this projector be operated without an adequate cabinet ground connection.
The AC supply must be installed by a qualified electrician in conformance to local codes. Hardware, wire sizes
and conduit types must comply with local codes.
Ventilation
To ensure that correct airflow is maintained, the projector must only operated when all the covers
are in place. The only exception is the front cover, see "Projector safe attachment points".
The free space necessary between the air intake and exhaust are shown below.
36
R5910123 /00
FL40 / FS40 Projectors
Procedure
Confirm that the installation area meets all technical and environmental
requirements
Decide where the projector will be mounted
Unpack the projector and confirm that all equipment is present and in
good working order
Mount the projector
Install the projector lens
Connect the source
Power up the projector
Set up the image
Ambient operating
temperature
+10 to +40 °C
+10 to +35 °C
900m
3
/hour
Relative Humidity
10 –80% RH
10 –80% RH
10 –80% RH
Power Requirement
100 –240V. 60 –50 Hz.
Storage condition
–20 to +60 °C, 10 – 90 %
RH
–20 to +60 °C, 10 – 90 %
RH
Not Applicable