Apply A Display Profile - Barco F50 User Manual

8.4 Apply a display profile
About
Main Menu — Picture — Profile
The projector has a selection of 6 predefined display profiles that can be used to optimize the display for different uses. Each of the
display profiles can be modified by the user. An asterisk (*) beside the profile name indicates that the original settings have been
changed. In addition, there is a custom profile where users can create and save their preferred settings.
Picture settings that can be modified in a profile are:
• BrilliantColor mode
• Gamma curve
• Color correction (white point)
• Lamp power
Changes to the current profile can be discarded by selecting, Main Menu — Picture — Profile Reset and then selecting current
profile and ok.
To reset all the display profiles to the factory settings, go to Main Menu — Picture — Profile Reset and select all profiles and
ok when prompted.
The table below shows the factory settings for each of the 6 predefined display profiles.
Profile Description
Standard
Presentation
Bright
Cinema
DICOM Digital Imaging and Communications
in Medicine (DICOM) compliant.
SRP™ Smear Reduction Processing. Not
available with High Brightness color
wheel.
601–0307–00 F50 25/02/2016
BrilliantColor Gamma
Color Dynamic
Bright Dynamic
Bright Computer 2
Off Film 2.2
Off DICOM 180
LUX
SRP Half Film 2.2
8. Set up the picture
Color Lamp Power
Correction
Off 350
Off 350
Off 350
On 350
On 350
Off 350
75