Barco F50 User Manual page 39

• The ambient air temperature of the room or enclosure should not be greater than 40°C, and there must be sufficient ventilation
area around the projector. See illustration below, or read "Installation conditions", page 31 for more detail.
500mm
20"
Image 5-3
• Use the throw ratio of the installed lens as a guideline for the projector's physical distance from the screen. See "Throw dis-
tance", page 38 for more information.
• Ensure that the source signal interface and cable lengths are matched to the installation. See user manual chapter "Input and
communication", page 45 for source—cable specifications. In general:
- HDBaseT and 3G-SDI are long-haul interfaces and suitable for bespoke installations using relatively long cables
- DP, HDMI, DVI and VGA are short-haul interfaces using pre-assembled cables with limited cable lengths. Using extended
cable lengths may result in reduced image quality as well as loss of control information such as EDID (Extended Display
Information Data).
• Wherever possible, the projector lens surface should be positioned so that it is perfectly perpendicular to the center of the
screen. Offset (lens shift), rather than physical angling, should be used primarily to correct any off-center positioning.
• Installing the projector on a tilt is not recommended, however if it is necessary to do so, ensure that it is within the following
guidelines:
The projector can be rotated up to ±20 degrees on the side-to-side-axis without influencing lamp performance, as shown in
image 5-4.
The projector can be rotated 360 degrees on the through-the-lens-axis.
Image 5-4
601–0307–00 F50 25/02/2016
500mm
+ 20˚
- 20˚
20"
Operating humidity: 20 - 80% RH
Mains power: 100 - 240V, 50-60Hz
Max. ambient air temp: +40˚C (+104˚F)
5. Installation
360˚
35