Select A Power Mode - Barco F50 User Manual

7. Change projector settings
7.1

Select a power mode

Power on/standby
Switch the projector ON using the POWER button on the keypad or wireless remote control. The LED status light flashes blue when
the projector warming up; a solid blue light will be displayed when the projector is on and running normally.
Press the POWER button twice to put the projector into STANDBY mode. The LED status light will flash yellow while the projector
is cooling down. A solid yellow light indicates the projector is in STANDBY mode.
DPMS
When activated, the Display Power Management Signalling (DPMS) system automatically puts the projector in standby mode after
a source is removed. If the projector is powered down in DPMS power save, it will automatically power back on when a valid source
is acquired.
DPMS is activated from the SETTINGS menu. Users select the timeout value in the DPMS TIMEOUT sub-menu.
Standby ECO
This power saving mode sends the projector into a deep sleep setting when in standby.
The projector is returned to normal operation by pressing the power button on the projector keypad or remote control, or remotely
via the RS232 connector using the ASCII protocol / Wake on LAN via the Ethernet.
Baud rate for RS232 communication is fixed at 19200 when the projector is in standby eco.
If DPMS is enabled in the SETTINGS menu, the projector will automatically wake out of Standby ECO mode and power back on
when a valid source is acquired from the following inputs:
• DP1 and DP2
• HDMI
• DVI
• VGA
• SDI 1 and SDI 2
64 601–0307–00 F50 25/02/2016