Fuses; Switching On/Off - Barco R9002380 Installation Manual

Power Connection
4. Loosen both screws of the protective cover and take off the cover (image 2).
5. Pull out the 'power selector plug' and re-insert it as illustrated, depending on the wall outlet in the room (image 3).
6. Re-mount the protective cover and secure with both screws.
7. Re-insert the module.
8. Fasten the front panel with the 2 retaining screws.
image 2
!"ÃW
image 3

Fuses

Warning
For continued protection against fire hazard :
- replace with the same type of fuse
- refer replacement to qualified service personnel
Fuse type : 2 x T5A/250V (Barco order number : R314104)

Switching on/off

The projector is switched ON and OFF using the power (mains) switch ON/OFF.
Pressed : ON
Not pressed : OFF
The projector can start now in the 'operational mode' (image displayed) or in the 'stand by mode', depending on the setting of the
power up mode in the projector set-up menu in the service mode.
Stand by indication lamp :
no light up : projector in operational mode
red : projector is in stand by.
5-2
!ÃW
1 2 3
1 2 3
1 2 3
5976067 BARCOCINE 7 151299