5.1 Power connection
5.1.1 AC Power (mains) cord conn ection
2
1
VIDEO
3
S-VIDEO
R
G
B
Use the supplied power cord to connect your projector to the wall outlet.
!
Plug the female power connector into the male connector [1] at the control panel.
!
The power input is auto-ranging from 90 to 240 VAC.
5.1.2 Fuses
For continued protection against fire hazard:
- refer replacement to qualified service personnel
- ask to replace with the same type of fuse.
5.1.3 Switching on
Use the
switch [2] to switch on. When
power
is visible, the projector is switched on.
When switching on with the
mode indication lamp is red.
5.1.4 Image projection
To start image projection:
! apply the appropriate voltage to the 24V interface. The
green.
! press the
'Stand by'
mode indication lamp
! press a digit button to select an input source. The
green.
R5976255 A
CS4 (2001-03)
TLAS
4
SDI
SDO
5
IEE 1394
6
TRIG
H/C
V
1
COMPUTER
2
MONITOR
Fuse type : T3.15 AH/250V
'0'
switch, the projector starts in the
power
button once on the local keypad or on the remote control. The
will be green.
MOUSE
RS 232 IN
RS 232 OUT
Comm. Port
AUDIO IN
A
AUDIO IN
B
AUDIO IN
is visible, the projector is switched off. When
standby mode
projector mode indication lamp
projector mode indication lamp
RC
C
AUDIO OUT
'1'
. The projector
will be
projector
will be
5-8