Setting the
Printer
Connection
DOC-06810 Rev. A
When an Objet 3D printer is installed, the server computer is connected to
that printer. Normally, there should be no reason to change this connection.
Occasionally, however, you may need to reset the connection, to connect
the server to another printer, or to use Objet Studio in off‐line mode
(without a printer connection).
To set (or change) the printer connection:
1. On the Job Manager ribbon, in the 3D Printer group, click
2. In the Set Printer dialog box, click
Figure 5-104: Connecting to a printer (A)
3. Enter the computer name or its IP address, or click
select it.
Figure 5-105: Connecting to a printer (B)
4. Click
.
OK
When the connection is established, Objet Studio is configured to
prepare print jobs for that printer.
If you can see the material levels in the Job Manager screen (see
figure 5-103 on page 71), Objet Studio is connected to the printer.
Objet1000 Plus User Guide
.
Connect
Browse
.
to find and
5–73