Tire; Chassis Bolts And Nuts - HYOSUNG 2010 ST7 Service Manual

2-23 PERIODIC MAINTENANCE

TIRE

Inspect Interval
Inspect Initial 1,000 km and Every 6,000 km thereafter.
TIRE TREAD CONDITION
Operating the motorcycle with excessively worn tires will
decrease riding stability and can lead to loss of control.
Inspect shortage of tire thread s depth by the
wear indicator .
Replace the front and rear tires at once when appear
the tire wear indicator .
TIRE PRESSURE
If the tire pressure is too high or too low, steering will
be adversely affected and tire wear increased.
Therefore, maintain the correct tire pressure for good
enter key roadability or shorter tire life will result. Cold
inflation tire pressure is as follows.
SOLO RIDING
COLD INFLATION
TIRE PRESSURE
KPa
Front 200
Rear 225

CHASSIS BOLTS AND NUTS

Inspect Interval
Tighten Initial 1,000 km and Every 6,000 km thereafter.
Check that all chassis bolts and nuts are tightened to
their specified torque. (Refer to page 9-19)
DUAL RIDING
2 2
kgf/cm psi KPa kgf/cm
2.00 30.0 225 2.25
2.25 33.0 250 2.50
tire
The standard tire on
120/80 - 16 60H for front and
170/80 - 15 77H for rear.
The use of tires other than those specified may
cause instability. It is highly recommended to use
a HYOSUNG Genuine Tire.
psi
33.0
36.0
Tire wear indicator
Tire wear indicator mark
CAUTION
is