HYOSUNG 2010 ST7 Service Manual page 251

8-47 CHASSIS
INSPECTION
Inspect the rear shock absorber for damage and oil
leakage. If any defects are found, replace the rear shock
absorber with a new one.
CAUTION
Do not attempt to disassemble the rear shock
absorber.
It is unserviceable.
REMOUNTING
Remount the rear shock absorber in the reverse order of
removal.
Pay attention to the following points :
Install the rear shock absorber and tighten the bolts
and nuts to the specified torque.
Shock absorber mounting nut (upper)
: 20 ~ 30 N m (2.0 ~ 3.0 kgf m)
Shock absorber mounting bolt (lower)
: 35 ~ 55 N m (3.5 ~ 5.5 kgf m)
SPRING PRE-LOAD ADJUS-
TMENT
Adjust the rear shock absorber spring pre-load.
Rear shock absorber
spring free length
Rear shock absorber
spring pre-load
WARNING
Unequal suspension adjustment can cause poor
handling and loss of stability.
Adjust the right and left shock absorber to the
same settings.
Service limit
200.0 mm (7.87 in)
Standard
2/5 position
① Rear shock absorber
①
②
② Pin spanner