HYOSUNG 2010 ST7 Service Manual page 55

Remove the engine pulley.
NOTE
If it is difficult to remove the engine pulley, loosen
the rear axle bolt, belt adjusters
additional belt slack. (Refer to page 2-15)
Remove the frame down tube. Remove the frame down tube.
Support the engine using an engine jack. Support the engine using an engine jack.
Remove the engine mounting nuts, bolts and engine Remove the engine mounting nuts, bolts and engine
mounting lock nuts with the special tool. mounting lock nuts with the special tool.
Engine mounting socket wrench (M20)
Remove the engine from the frame.
CAUTION
Remove the throttle body when removing or
installing the engine necessarily.
When removing the throttle body, loosen the
intake pipe mounting bolts at the same time.
① ① ② ② to provide
: 09940H30010
ENGINE 3-8
①
②