HYOSUNG 2010 ST7 Service Manual page 97

MAGNETO ROTOR
Fit the key into the key slot on the crankshaft.
With the magneto rotor, install the starter clutch on
the crankshaft.
Apply a small quantity of THREAD LOCK 1324 to
the threaded parts of crankshaft.
THREAD LOCK 1324
Tighten the magneto rotor bolt to the specified
torque.
Conrod holder : 09910-20115
Magneto rotor bolt
: 110 ~ 170 N m (11.0 ~ 17.0 kgf m)
STARTER IDLE GEAR AND
MOTOR
Install the starter idle gear, shaft.
Install the starter motor.
ENGINE 3-50