Dealer Mode - HYOSUNG 2010 ST7 Service Manual

4-11 EI SYSTEM DIAGNOSIS
⊙ ⊙ DEALER MODE
The defective function is memorized in the ECU.
The memorized malfunction code is displayed on the LCD (DISPLAY) panel
" " .
Malfunction means that the ECU does not receive signal from the devices or fault signal received.
These affected devices are indicated in the code form on the LCD (DISPLAY) panel
the "FI" check lamp "
A. LCD (DISPLAY) PANEL
To confirm the memorized malfunction code :
1. Remove the front seat.
2. Connect the special tool to the dealer mode coupler at the wiring harness, and the ignition switch is set to "ON" posi-
tion.
Mode select switch : 09900-27000
3. Turn the special tool's switch "ON" position.
4. Push the select switch
This time, if not connect the special tool, the clock indicates the "cHE" letters then disappear.
5. The memorized malfunction code is displayed on the LCD (DISPLAY) panel
The malfunction code is indicated in the code form.
6. Start the engine and repeat the above procedure.
7. Check the malfunction code to determine the malfunction part.
8. Push the select switch
played the CLOCK.
The malfunction code of the LCD (DISPLAY) panel
" .
(in the normal mode) for 5 seconds.
(in the malfunction code mode) for 0.6 ~ 1 seconds, then the LCD (DISPLAY) panel
or with blinks signal of the "FI" check lamp
NOTE
NOTE
is displayed the current code(s).
or displayed with blinks signal of
.
is dis-