HYOSUNG 2010 ST7 Service Manual page 104

3-57 ENGINE
Put the intake or exhaust camshaft housing to the
cylinder head upper surface.
Tighten the camshaft housing bolt with the specified
torque diagonally.
CAUTION
The camshaft housing bolt is made of the special
material.
This bolt is superior at the degree of hardness
more than the different high tension bolt.
Pay special caution that the different type of bolt
should not be used.
This bolt head is punched the 9 mark.
Camshaft housing bolt
If turn the lock shaft handle in clockwise (
direction, the pushrod is inserted in.
Turn the mechanical spring continually until the han-
dle is turned to the end.
Fix the adjuster into the cylinder block.
Get out the pushrod for the front to turn the lock shaft
handle in counter-clockwise (
: 12 N m (1.2 kgf m)
).
)
Lock shaft handle