Inspection And Cleaning; Oil Filter Replacement - HYOSUNG 2010 ST7 Service Manual

INSPECTION AND CLEANING

Check the oil jets for clogging.
If they are clogged, clean their oil passage with a
proper wire and compressed air.
INSTALLATION
Fit the new O-ring to each oil jets.
CAUTION
Use the new O-ring to prevent oil leakage.
Apply engine oil to the O-ring.
Install the oil jet ① to the oil hole of crankcase.
NOTE
Push the oil jet the crankcase until it stops.
CLUTCH COVER

OIL FILTER REPLACEMENT

(Refer to page 2-14)
DISASSEMBLY
Remove the circlip and right crankshaft oil seal.
Oil seal remover : 09913-50121
①
ENGINE 3-34