HYOSUNG 2010 ST7 Service Manual page 242

After loosening the disk mounting bolts, remove the
rear brake disk cover and brake disk.
Remove the spacer ①.
Remove the rear pulley ② with the rear pulley
mounting drum ③ from the rear wheel.
NOTE
Before separating the rear pulley and rear pulley
mounting drum, slightly loosen the rear pulley
bolts.
Remove the rear wheel shock absorber ④.
Remove the rear pulley ② from the rear pulley
mounting drum.
WHEEL BEARING REMOVAL
Remove the bearing using the special tool.
Wheel bearing remover : 09941-50111
CAUTION
The removed bearing should be replaced with
new one.
INSPECTION
WHEEL AXLE : Refer to page 8-8
WHEEL : Refer to page 8-8
WHEEL BEARING : Refer to page 8-8
TIRE : Refer to page 2-23
④ ③
①
CHASSIS 8-38
②