Tire; Chassis Bolts And Nuts - HYOSUNG COMET 125 Service Manual

TIRE

Inspect Interval
Inspect Initial 1,000 km and Every 4,000 km.
TIRE TREAD CONDITION
Operating the motorcycle with excessively worn tires will
decrease riding stability and can lead to loss of control.
Inspect shortage of tire thread s depth by the
wear indicator .
Replace the front and rear tires at once when appear
the tire wear indicator .
TIRE PRESSURE
If the tire pressure is too high or too low, steering will be
adversely affected and tire wear increased. Therefore,
maintain the correct tire pressure for good roadability or
shorter tire life will result. Cold inflation tire pressure is
as follows.
SOLD RIDING
COLD INFLATION
TIRE PRESSURE
KPa
Front
196
Rear
221

CHASSIS BOLTS AND NUTS

Inspect Interval
Tighten Initial 1,000 km and Every 4,000 km.
Check that all chassis bolts and nuts are tightened to
their specified torque.(Refer to page 7-12)
DUAL RIDING
2 2
kgf/cm psi KPa kgf/cm
2.00 29.0 196 2.00
2.25 32.0 245 2.50
tire
The standard tire on
is 110/70-17 54H for front and
150/70-17 69H for rear.
The use of tires other than those specified
may cause instability. It is highly recommended to
use a HYOSUNG Genuine Tire.
psi
29.0
36.0
PERIODIC MAINTENANCE 2-18
Tire wear indicator
Tire wear indicator mark
CAUTION