HYOSUNG 2010 ST7 Service Manual page 248

CALIPER REASSEMBLY
AND REMOUNTING
Reassemble and remount the caliper in the reverse
order of removal and disassembly procedures and
observe the following points.
CAUTION
Wash the caliper components with fresh brake
fluid before reassembly. Do not wipe off brake
fluid after washing the components.
When washing the components, use the spci-
fied brake fluid. Never use different types of
fluid or cleaning solvent such as gasoline,
kerosine or the others.
Replace the piston seal and dust seal into new
ones with brake fluid applied.
Brake fluid specification and classification
Install the brake pad spring.
Apply SILICONE GREASE to the brake caliper hold-
er.
SILICONE GREASE
Install the brake pads. (Refer to page 2-18)
Tighten the caliper mounting bolts ① and brake hose
union bolt ② to the specified torque.
Rear brake caliper mounting bolts
: 18 ~ 28 N m (1.8 ~ 2.8 kgf m)
Rear brake hose union bolts
: 20 ~ 25 N m (2.0 ~ 2.5 kgf m)
NOTE
Before remounting the caliper, push the piston all
the way into the caliper.
: DOT 4
②
CHASSIS 8-44
①