HYOSUNG 2010 ST7 Service Manual page 79

STARTER CLUTCH
Install the starter driven gear onto the starter clutch and
turn the starter driven gear by hand(the gear turns in
only one direction). The starter driven gear should turn
smoothly. If excessive resistance is felt while turning the
starter driven gear, inspect the starter clutch. Also,
inspect the surface of the starter driven gear which con-
tacts the starter clutch, for wear or damage. If any wear
or damage is found, replace the defective parts.
DISASSEMBLY
With the magneto rotor held immovable, remove the
starter clutch bolts.
REASSEMBLY
Apply a small quantity of THREAD LOCK 1324 to
the starter clutch bolts and tighten them to the spec-
ified torque with the magneto rotor held immovable.
Thread Lock 1324
Starter clutch bolt
: 23 ~ 28 N m (2.3 ~ 2.8 kgf m)
STARTER DRIVEN GEAR
STARTER DRIVEN GEAR BUSH
Install the starter driven gear bush ① and gear ② onto
the crankshaft and turn the starter driven gear by hand.
Inspect the starter driven gear bush for smooth rotation
and any abnormal noise. If the bush does not turn
smoothly or there is any abnormal noise, replace it.
②
①
ENGINE 3-32