HYOSUNG 2010 ST7 Service Manual page 94

3-47 ENGINE
PRIMARY DRIVEN GEAR
NOTE
Apply the engine oil to the inside face of primary
driven gear bearing.
Install the primary driven gear assembly.
CLUTCH
Install the clutch sleeve hub ①, lock washer ②.
Install the clutch sleeve hub nut, and tighten it to the
specified torque using the special tool.
Clutch sleeve hub holder : 09920-53710
Clutch sleeve hub nut
: 40 ~ 60 N m (4.0 ~ 6.0 kgf m)
Bend the lock washer securely.
Install the clutch drive plate NO. 2
Install the spring washer seat
onto the clutch sleeve hub correctly.
Install the clutch driven plates
NO. 1 one by one into the clutch sleeve hub in the
prescribed order.
and spring washer
and drive plates
①
②