HYOSUNG 2010 ST7 Service Manual page 272

Special tools Part Number Part Name Description
Part Number Part Name Description
09910-20115
Conrod holder
Used to lock the crankshaft.
09910-32812
Crankshaft installer
Used to install the crankshaft in the crankcase.
09910-32813
Crankshaft installer adapter
Used to with the crankshaft installer.
09910-34510
Piston pin puller
Use to remove the piston pin.
09913-50121
Oil seal remover
Used to remove the oil seal.
09913-70122
Bearing installer
Used to drive bearing in.
09913-75820
Bearing installer
Used to drive bearing in.
09913-76010
Bearing installer
Used to drive bearing in.
09913-80112
Bearing installer
Used to drive bearing in.
SERVICING INFORMATION 9-16
Special tools Part Number Part Name Description
09915-54510
Fuel pump pressure gauge
Measure fuel pressure of fuel pump.
09915-64511
Compression gauge
Measure cylinder compression.
09915-74511
Oil pressure gauge
Measure oil pressure of 4-stroke engine.
09916-14510
Valve spring compressor
Used to remove and remounting valve stem.
09916-14520
Valve spring compressor attachment
Used with valve spring compressor.
09920-13120
Crankcase separater
Separate to crankcase.
09920-53710
Clutch sleeve hub holder
Used to install or remove clutch sleeve hub nut.
09921-20200
Bearing remover (10mm)
Used to remove bearing with the rotor remove sliding shaft.
09921-20210
Bearing remover (12mm)
Used to remove bearing with the rotor remove sliding shaft.