Nortel BCM50 Installation And Maintenance Manual page 166

166 Chapter 18 Testing basic BCM50 functionality
Table 32 Level 1 reset
Step User action
1 Boot the system
Press reset switch
2
Wait five seconds
3
4
Press reset switch
Table 33 Level 2 reset
Step User action
1 Boot up the system
Press reset switch
2
Press reset switch
again within five
seconds of the first
3
button press.
Wait five seconds
4
Press reset switch
5
N0027152 01 N0027152 01
Power LED Status LED
Solid yellow Solid yellow
Solid yellow Off
Flashing yellow Solid yellow
Solid red Flashing yellow
Flashing red Flashing yellow
Solid red Solid yellow
Solid green Solid green
Power LED Status LED
Solid yellow Solid yellow
Solid yellow Off
Flashing yellow Solid yellow
Solid red Flashing yellow
Solid red Flashing red
Flashing red Flashing red
Solid red Solid red
Solid green Solid green
System state Alternative user action
Power self-test
No action – system
Power self-test
remains off
Ready for reset input
Do not press reset
Request Level 1 reset switch – system boots
normally
Press reset switch –
Awaiting Level 1 reset
system proceeds to
confirmation
Level 2 reset
System performs
Level 1 reset
All configuration
Do not press reset
programming erased.
switch – system boots
normally
System has rebooted,
and is ready for user
action.
System state Alternative user action
Power self-test
No action – system
Power self-test
remains off
Ready for reset input
Do not press reset
Request Level 1 reset switch – system boots
normally
Do not press reset
Request Level 2 reset switch – system remains
in Level 1 reset state
Press reset switch –
Awaiting Level 2 reset system proceeds to
confirmation Nortel factory mode (do
not use)
System performs
Level 2 reset – All
configuration
programming and
Do not press reset
software updates
switch – system boots
erased.
normally
System has rebooted,
and is ready for user
action.