To Remove The Mbm - Nortel BCM50 Installation And Maintenance Manual

180 Chapter 22 Replacing a media bay module

To remove the MBM

1 Use Element Manager to disable the MBM you are removing. Refer to the BCM50
Administration Guide (N0016868) for more information on disabling an MBM.
2 If the expansion unit is wall-mounted, it must be removed from the wallmount bracket before
removing the MBM. Refer
more information, then proceed to step 7.
3 Disconnect all of the telephone line and extension cables from the MBM.
If there is more than one cable, mark the cables to identify the port from which they were
removed.
4 Rotate the power supply retention clip to free the power supply cord.
5
Remove the power supply cord from the expansion unit.
6 Attach one end of the grounding strap to your wrist and the other end to a grounded metal
surface.
7
Pull the ejector lever out with your index finger. Then grasp the ejector lever with your thumb
and index finger and pull outward to disengage the MBM (see
MBM by hand.
Figure 67 Remove an MBM
8 Grasp the top and bottom edges of the MBM. Remove the MBM from the expansion unit.
Place the MBM in a flat, clean, static-free surface.
Warning: Protect the hardware components against damage from electrostatic
discharge. Always wear a ground wrist strap before you handle components. Always
place the components in a static-free container.
9
Proceed to
N0027152 01 N0027152 01
to"To remove a wallmounted expansion unit" on page 185
"To insert the new MBM".
Figure 67). Finish removing the
Grasp the edge of the MBM
ejector lever and pull outward
for