To Install An Auxiliary Ringer; To Install An External Paging System; Connecting An External Paging System - Nortel BCM50 Installation And Maintenance Manual

108 Chapter 9 Connecting the cables to the BCM50 system

To install an auxiliary ringer

1 Use the installation instructions that came with the ringer hardware to install the auxiliary
ringer.
2 Connect the ringer generator to the auxiliary ringer output pair on the RJ-21 telephony
connector. Refer to the
which pair of wires is used for the auxiliary ringer.
Warning: The auxiliary ringer must not be connected to unprotected plant wiring.
The ringer must not draw more than 50 mA from a 40 V dc source.
3 Select the appropriate option for your system:
• If you are adding more auxiliary equipment, proceed to
system"
• If you are finished adding auxiliary equipment, proceed to

Connecting an external paging system

You can connect a customer-supplied external paging system to provide paging over external
loudspeakers.
Ensure the paging system follows these guidelines:
The paging output from the main unit is 100 mV rms across an input impedance of 600 Ω.
•
• The output level is 0 dBm0 with reference to 600 ohms, for a PCM encoded signal at 0 dBm.
There is no dc voltage across the page output terminals.
When you use the page signal output to connect an external paging amplifier, you also use the
page relay output which contains a floating relay contact pair. The system uses this output to
control the external paging amplifier.
• The contact pair for the page relay output has a switch capacity of 50 mA (non-inductive) at
40 V (maximum).

To install an external paging system

1 Use the installation instructions that came with the external paging hardware to install the
external paging system.
2 Connect the paging system audio input to the page output on the RJ-21 telephony connector.
Refer to the
wires is used for the page output.
3 Connect the paging system relay to the page relay output on the RJ-21 telephony connector.
Refer to the
wires is used for the page relay output.
N0027152 01 N0027152 01
"RJ-21 telephony connector wiring chart" on page 205
or "Connecting an external music source" on page
"RJ-21 telephony connector wiring chart" on page 205
"RJ-21 telephony connector wiring chart" on page 205
to determine
"Connecting an external paging
109.
"Next step" on page
to determine which pair of
to determine which pair of
112.