To Remove A Rackmounted Expansion Unit; To Remove A Wallmounted Expansion Unit; To Remove A Desktop-Mounted Expansion Unit - Nortel BCM50 Installation And Maintenance Manual

To remove a rackmounted expansion unit

1 Ensure that all of the cables are removed from the expansion unit.
If they are not, refer to
2 If there is a unit mounted to the top of the expansion unit, slide that unit forward until it
disengages from the clips on the expansion unit. Lift the unit off the top of the expansion unit.
3
If the expansion unit is mounted on top of another unit, slide the expansion unit forward until
it disengages from the clips of the other unit. Go to step 6.
If the expansion unit is not mounted on top of another unit, continue to the next step.
4 If the expansion unit has been secured to the rackmount shelf with screws, remove these
screws from the bottom of the rackmount shelf.
5
Slide the expansion unit forward until is disengages from the clips on the rackmount shelf.
6 Lift the expansion unit off of the rackmount shelf or other unit and set it on a flat, clean,
static-free surface.
7
Continue to the next step,

To remove a wallmounted expansion unit

1 Ensure that all of the cables are removed from the expansion unit.
If they are not, refer to
2
Lift the expansion unit up until it disengages from the clips on the wallmount bracket.
3 Pull the expansion unit out and away from the wallmount bracket.
4 Set the expansion unit on a flat, clean, static-free surface.
5
Continue to the next step,

To remove a desktop-mounted expansion unit

1 Ensure that all of the cables are removed from the expansion unit.
If they are not, refer to
2
If there is a unit mounted to the top of the expansion unit, slide that unit forward until it
disengages from the clips on the expansion unit. Lift the unit off the top of the expansion unit
and set it on a flat, clean, static-free surface.
3 If the expansion unit is mounted on top of another unit, slide the expansion unit forward until
it disengages from the clips of the other unit.
4
Lift the expansion unit off of the table or other unit and set it on a flat, clean, static-free
surface.
5
Continue to the next step,
"To disconnect the expansion unit cables" on page
"To remove the MBM" on page
"To disconnect the expansion unit cables" on page
"Removing the MBM" on page
"To disconnect the expansion unit cables" on page
"Removing the MBM".
Chapter 23 Replacing an expansion unit
180.
186.
BCM50 Installation and Maintenance Guide
185
184.
184.
184.