Verifying The Media Bay Module Switch Settings - Nortel BCM50 Installation And Maintenance Manual

Verifying the media bay module switch settings

Each MBM has dip switches on the back or underside of the module (see
Figure 40 Switches on the media bay module (not applicable for GASM or GATM)
Back of the media bay module
Note: The GASM and GATM MBMs have a different dip switch configuration
than shown in
"To set GATM dip switches" on page 94
Verify that the dip switches for your MBMs are in the default factory positions as follows:
If you are installing a DTM, BRIM, 4x16, DSM16, DSM32, or ASM8, ensure that all the switches
are on. This is the default setting for the MBM switches. After you have set the switches, proceed
to "Installing a media bay module in an expansion unit" on page
Caution: The MBM dip switches must remain in their default factory position.
Any required modifications to the MBM settings are made through the software.
Underside of the
media bay module
6 5 4 3 2 1
dip switches
Rear view of the media bay module
Figure 40. Refer to "To set GASM dip switches" on page 94
Chapter 8 Installing an expansion unit
Off
On
On
1 2 3 4 5 6
Off
for more information.
95.
BCM50 Installation and Maintenance Guide
93
Figure 40).
Module is
right-side up
and