To Configure The Modem; To Configure The Start-Up Template For Telephony Services; To Initialize Voice Mail - Nortel BCM50 Installation And Maintenance Manual

136 Chapter 14 Using Element Manager to set the basic parameters

To configure the modem

1 From the Configuration tab, click the Administrator Access folder to expand it.
2 Select Modem from the Administrator Access folder.
3
Select or deselect the Enable modem checkbox, depending on your system requirements.
For more information on modem configuration, refer to the BCM50 Networking Configuration
Guide (N0027156).

To configure the start-up template for telephony services

Note: This procedure erases all the telephony programming that is currently on
BCM50 the system.
1 From the Administration tab, click the Utilities folder to expand it.
2
Select Reset from the Utilities folder.
3 Click Cold Reset Telephony Services. The Cold Reset Telephony dialog box opens.
4 Configure the Cold Reset Telephony attributes (see
Table 23 Cold Reset Telephony attributes
Attribute
Region
Template
Start DN
5
Click Ok.

To initialize voice mail

1 From the Configuration tab, click Applications folder to expand it.
2 Select Voice Messaging/Call Center from the Applications folder.
3
Click Launch CallPilot Manager. The Quick Install Wizard form opens.
If your voice mail system is already initialized, you will not see the Quick Install Wizard.
Instead you will see the System Properties web page.
N0027152 01 N0027152 01
Table
Description
Specify the startup region.
Specify the startup template.
Specify the startup DN. The default is 221.
23).