Remotely Setting The Interface Language - RADVision SCOPIA XT4000 Series User Manual

Procedure
Step 1
Step 2
Note
Step 3
Step 4
Step 5

Remotely Setting the Interface Language

This procedure describes how to set the language of the endpoint from the SCOPIA XT Series
web interface. You can also do this from the endpoint itself, as described in
System Name and Language" on page
Procedure
Step 1
RADVISION | User Guide for SCOPIA XT4000 Series Version 3.1
Set the Use Gatekeeper list to Yes.
Set the Mode list to Manual.
If the gatekeeper is configured to be automatically detected by endpoints, select
Automatic (depends on the type of gatekeeper). Consult the network administrator.
Enter the IP address of the gatekeeper in the Gatekeeper IP address field.
Enter the H.323 number required to dial the XT Codec Unit in the E.164 field.
Select Done.
The basic configuration of your SCOPIA XT Series is complete.
Access the SCOPIA XT Series web interface.
Figure 2-13 Gatekeeper settings
10.
"Setting the
Getting Started | 16