Setting The Interface Language - RADVision SCOPIA XT4000 Series User Manual

Step 2
Step 3
Step 4
Step 5

Setting the Interface Language

You may set the interface language in the Quick Setup Wizard or from the SCOPIA XT Series
web interface.
Procedure
Step 1
Step 2
RADVISION | User Guide for SCOPIA XT4000 Series Version 3.0
Set the Mode list to Manual.
Enter the IP address of the gatekeeper in the IP address field.
Enter the H.323 number required to dial the XT Codec Unit in the Number H.323 field.
Select Done.
The basic configuration of your SCOPIA XT Series is complete.
Access the SCOPIA XT Series web interface.
Select the User settings tab.
The User Preferences page opens.
Figure 3-6 XT Codec Unit
Getting Started | 14