Headlight; Adjusting The Beam - Malaguti SPIDER MAX GT500 Owner's Manual

5.16 HEADLIGHT

• To increase visibility at night, quartz (halogen) type headlights
are fitted.
• Low beam / high beam (A - Fig. 38)
Halogen bulb 12V - 35/35 W (HS1)
• Parking light bulb (B - Fig. 38)
Bulb 12V - 5W (W5W)
• Front turn indicator (C - Fig. 38)
1
Orange bulb 12V - 21W (PY21)
For information about light controls, see § 3.12 and 3.13
2 We advise you to check if the replaced bulb works
properly before refitting the headlight unit definitively.

5.17 ADJUSTING THE BEAM

3
Have the beam of the headlight periodically checked by an
Authorised MALAGUTI Service Centre.
4
To check/adjust the beam, proceed as follows:
• put the vehicle in running conditions at 10 metres from a wall.
• Turn on the low beam headlights and keep the vehicle bal-
anced without a stand (lean it against a wall for instance).
5
• turn the adjustment knobs of the two projectors (D - Fig. 38a)
one at a time, bearing in mind that turning clockwise lowers
the beam, and anti-clockwise raises it.
Adjust the beam so that its bottom line projected on the wall is at
6
about 78 cm from the floor.
44
ENGLISH
B
C
A
Fig. 38
D
Fig. 38a