CHECKING THE PADS AND DISC OF THE
FRONT BRAKE (CONDITION AND WEAR)
1 - We recommend you to check the front pads and disc
every 2,500 km (1,560 mi).
2 - The minimum thickness of the brake lining shall not
be less than 2 mm (Fig. 25). Check the thickness of
the brake pads as illustrated in Fig. 26.
3 - If the thickness of the pads is close to the lowest per-
mitted limit or if they are damaged, have them
replaced immediately.
CHECKING THE REAR BRAKE
- Check whether the lever's stroke is as illustrated in
Fig. 27. The idle stroke of the lever is approximately 10
mm.
- To adjust the rear brake, turn the adjuster under the en-
gine, as illustrated in Fig. 28.
HEADLIGHT
To increase visibility at night, quartz (halogen) type head-
lights are fitted.
- Low beam / high beam (A-Fig. 29)
Bulb 12V - 25/25W
- Parking light bulb (B-Fig. 29)
Bulb 12V - 5W
NOTE - We advise you to check if the replaced bulb works
properly before refitting the headlight unit defini-
tively.
FRONT TURN INDICATOR
- Front turn indicator (C-Fig. 29)
Orange lamp 12V - 10W
The rate at which the turn indicator warning light
on the instrument board flashes will increase to
signal that one of the four indicators is not work-
ing.
10 mm
Fig. 27
11
03/10
MIN. 2mm
Fig. 25
A
B
C
Fig. 26
NO
OK
Fig. 28
Fig. 29