Connecting Devices To The Projector - Christie CP2208 Installation And Setup Manual

d. Hold the anode end of the new lamp in your left hand and angle it up through the hole in
the back of the reflector assembly. Insert your right index and middle finger through the
back of the reflector and thread the cathode end of the lamp into the extension nut.
When threading the lamp into the extension nut, make sure the anode wire does not hit
the reflector or the UV filter.
e. Tighten the extension nut screw.
f. Move to step 13.
12. For CDXL-19SC or CDXL-21S1 lamps:
a. Hold the anode end of the new lamp in your left hand and angle it up through the hole in
the back of the reflector assembly. Insert your right index and middle finger through the
back of the reflector and guide the lamp onto the cathode clamp. Be careful not to hit the
lamp against the reflector
b. Thread on and hand-tighten the cathode nut. Ensure the smooth portion of the nut is
against the cathode clamp.
c. Tighten the cathode screw (D) with a hex key.
13. Align the ring terminal on the anode wire with the mounting position ensuring the crimped side
of the wire is facing out. Tighten the anode screw. Route anode lead away from nearby metal
surfaces.
14. Close the lamp access door and tighten the two thumbscrews.
15. Close the fire wall door and tighten the two thumbscrews.
16. Close and lock the rear access door. Ensure the hex key is placed back into its holder before
closing the rear access door.

Connecting devices to the projector

To display content, you must connect a device that is capable of storing or playing content to the
projector.
CP2208 Installation and Setup Guide
020-102031-01 Rev. 1 (09-2015)
Installation and setup
17