Christie CP2208 Installation And Setup Manual page 24

6. Complete a coarse lamp adjustment:
a. Locate the Y axis adjustment label on the operator side of the projector.
b. Insert a 5 mm hex driver through the louvers at an angle below the Y axis adjustment
label until it is firmly seated on the Y axis adjustment screw.
c. Turn the screw clockwise or counterclockwise until the value in the Intensity field peaks
and then reduces.
d. Remove the hex driver and repeat steps a to c to adjust the Z and X axis.
7. Complete a fine lamp adjustment:
a. Locate the Y axis adjustment label on the operator side of the projector.
b. Insert a 5 mm hex driver through the louvers until it is firmly seated on the Y axis
adjustment screw.
c. Turn the screw slowly clockwise or counterclockwise until you determine the highest
value.
d. Remove the hex driver and repeat steps a to c to adjust the Z and X axis.
8. Verify the value in the Intensity field is greater or equal to the number you recorded in step 4.
If value is lower, repeat steps 6 and Step 7.
CP2208 Installation and Setup Guide
020-102031-01 Rev. 1 (09-2015)
24