Connecting The Projector To A Computer; Connecting Devices To The 3D Sync Terminal; Connecting Power - Christie CP2208 Installation And Setup Manual

Item Description
Indicates marriage status. In full power mode, a green LED indicates that the projector is properly
E
married and encrypted content can be displayed. A red LED indicates marriage is broken and encrypted
content cannot be displayed.
Turns the projector and the lamp on and opens the douser. Press and hold the button to close the douser,
F
turn the lamp off, and keep the power on. It is recommended that you use this button only when the TPC
is unavailable.
Resets the projector electronics. After restarting, the projector returns to its previous power mode. You
G
must strike the lamp manually.
Connects the projector to 3D devices such as MasterImage or RealD.
H
Connects the projector to Christie or third-party automation equipment. Utilizes the Christie-proprietary
I
protocol.
Connects the projector to a 10Base-T/100Base-TX Ethernet connection.
J
Connects the projector to high-definition cinema sources. The connectors can be used together to deliver
K
Dual Link HD-SDI following the SMPTE 372M standard.

Connecting the projector to a computer

Connect one end of an Ethernet or a RS232 cable to the Ethernet or the RS232 PIBS1 ports on the
projector communications panel and the other end to your computer. To communicate with the
projector, the projector must be added to the same network as the computer.
For more information see the CP2208 User Manual (P/N: 020-101916-XX).

Connecting devices to the 3D sync terminal

For information about connecting devices to the 3D sync terminal, see the CP2208 User Manual (P/N:
020-101916-XX).

Connecting power

• In all countries with IT power distribution systems, a dedicated protected earth wire must be
installed on the projector before it can be connected to power. To connect the projector to an IT
power distribution system you must connect the building ground to the external ground lug next to
the AC receptacle on the rear corner of the projector.
• The dedicated earth wire can only be installed by a Christie accredited service technician or an
electrician. The protected earth wire must be green/yellow 12 AWG minimum. See
requirements
serious injury.
• Do not operate the projector if the AC power supply and cord are not within the specified voltage
and power range. Only use the power cord supplied with the projector. Failure to comply could
result in minor or moderate injury.A dedicated, protected earth wire must be installed on the
projector before it can be connected to power. You must use a 20A branch circuit breaker for Input
A. Install the projector near an AC receptacle that is easily accessible. Failure to comply could
result in minor or moderate injury.
1. If the projector is operating, turn it off and disconnect it from AC power.
CP2208 Installation and Setup Guide
020-102031-01 Rev. 1 (09-2015)
on page 30 for power requirements. Failure to comply could result in death or
Installation and setup
Power
19