Christie CP2208 Installation And Setup Manual page 10

3. Insert an M6 screw (012-101132-XX) through the stacking cup mounting hole and into the
projector.
4. With a torque wrench, tighten the M6 screw to 15 in-lb.
5. Repeat steps 3 to 5 to install the three remaining stacking cups.
6. With the assistance of another person, lift the second projector and position it on top of the
bottom projector so each of its feet fit into a stacking cup. The lenses of both projectors must
face the same direction and the optical axis of both projector lenses must be parallel (A) and
align vertically (B).
7. Complete the installation for both projectors, including:
a. Install the touch panel controller. See
b. Install the lens. See
c. Install the lamp. See
d. Connect devices to the projector. See
e. Connect power. See on page 20.
f. Adjust the bottom projector image to fit the screen. For more information see the
CP2208 User Manual (P/N: 020-101916-XX).
g. Align the top projector image to the bottom projector image. For more information see
the CP2208 User Manual (P/N: 020-101916-XX).
8. When both projectors are installed and aligned correctly, install the locking brackets on the feet
of the top projector:
a. Slide the locking bracket (011-104470-XX) over the flat sides of the stacking cup, so the
notch in the locking bracket fits around the projector leg and above projector foot nut.
CP2208 Installation and Setup Guide
020-102031-01 Rev. 1 (09-2015)
Installing the touch panel controller
Installing the lens on page 12.
Installing the lamp on page 14.
Connecting devices to the projector
Installation and setup
on page 12.
on page 17.
10